Brandmotion 2000-3811 - Manual (Page 5)

Section 2: Scion tC, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 5 of 54
9. Route the DPS harness along the factory harness and
up to the radio area. Using supplied Wire Ties, secure
DPS harness to factory harness away from any moving
parts.
10. Secure DPS harness to dash brackets with two
supplied 8.5” Wire Ties.
11. Secure DPS harness to factory harness with two
supplied 8.5” Wire Ties.
12. Connect the DPS harness into the radio and connect
the factory radio plug into the other end of the DPS
harness. Reconnect all connectors and antenna.
13. Reinstall radio.
14. Reconnect vehicle battery. Re-torque battery bolt to
36 inch lbs.
15. Place DPS module with the Bongiovi DPS Acoustics
side face down. Then confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”.
22. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
23. Unplug the small 4-pin connector from DPS module.
16. Set the DPS dip switches for Scion tC. The first, third,
fourth, and fifth switches should be set to the “up”
position.