Brandmotion 2000-3811 - Manual (Page 31)

Section 11: Toyota Matrix, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 31 of 54
10. Remove 4 bolts retaining radio bracket. Disconnect
each connector and remove radio with bracket.
11. Locate an area under the dash to which to mount
the DPS module. Do not mount where moving parts
or sharp edges could damage wire harness. Do not
secure DPS module with supplied 24” wire ties yet.
12. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
13. Reinstall radio.
14. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
15. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
16. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
17. Unplug the small 4-pin connector from DPS module.
18. Set DPS dip switches for Matrix. The first and
third switches should be flipped to the “up”
position – “UDUDD”:
19. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
20. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
21. Turn ignition key to “LOCK” (OFF) and remove key.
22. Secure DPS module behind dash using supplied 24”
wire ties. Use side cutters to trim excess wire tie.
23. Re-install removed parts in reverse order of removal.
24. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.