Brandmotion 2000-3811 - Manual (Page 7)

Section 3: Scion xB, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 7 of 54
1. Ensure all radio functions are working properly, return all
Treble, Bass, Fade, and Balance to neutral settings and
remove any CDs to avoid possible jam before
disassembly.
2. For vehicles equipped with automatic transmissions, place
shifter in the N (neutral) position and set parking brake.
3. Loosen the negative battery cable bolt with 10mm socket.
Remove negative battery cable from terminal and position
away from battery.
4. Disengage 4 clips and 3 claws securing instrument
cluster finish center panel and remove it.
5. Remove 4 bolts securing the radio and remove the radio
with bracket. Disconnect the connectors.
6. Disengage the claw and disconnect glove compartment
door stopper. Slightly flex the upper part of the glove
compartment door to release the 2 stoppers and open
glove compartment door until it is horizontal.
7. Pull the glove compartment door out horizontally to
disengage the 2 hinges and remove the glove
compartment door. NOTICE: Pull the glove compartment
door out horizontally, otherwise, installation failure
caused by excessive play around the hinge will result.
8. Place DPS module under RH dash glove box area. Do not
secure with supplied 24” wire ties at this time. Route the
DPS wire harness up and over heater control as shown.
IMPORTANT: DPS is NOT compatible
with factory JBL audio systems.