Brandmotion 2000-3811 - Manual (Page 37)

Section 13: Toyota RAV4, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 37 of 54
17. Reinstall radio.
18. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
19. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
20. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
21. Unplug the small 4-pin connector from DPS module.
22. Set the DPS dip switches for RAV 4 according to the
vehicle audio system (4 speaker or 6 speaker):
A. For the
RAV 4 6-speaker system , the first,
second, and third switches should be flipped to
the “up” position – “UUUDD”:
B. For the RAV 4 4-speaker system , the second and
third switches should be flipped to the “up”
position — “DUUDD”:
23. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
24. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
25. Turn ignition key to “LOCK” (OFF) and remove key.
26. Secure DPS module using supplied 24” wire ties. Pull
wire ties tight and use side cutters to trim excess.
27. Re-install removed parts in reverse order of removal.
28. Clean dash using a 50/50 mix of alcohol and water
and install DPS badge.