Brandmotion 2000-3811 - Manual (Page 24)

Section 8: Toyota Corolla, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 24 of 54
16. Remove right front seat bolts. Slide seat rearward
and disengage 4 claws on front trim covers then
remove 2 bolts.
17. Slide seat forward and disengage 4 claws on rear
trim covers and then remove 2 bolts.
18. Without disconnecting wires, tilt the seat back and
rest the seat on rear seat for support. IMPORTANT:
Do not remove wires from seat or it will be
necessary to re-calibrate occupant safety sensitivity
which requires a special programming tool.
19. Place DPS module between right seat tracks. Make a
mark on front and rear side of DPS module. Using a
utility knife, make a 1” long slit in the carpet on
either side of the DPS module. Do not secure with
supplied 24” wire ties at this time.
20. Place DPS module under seat and route harness
through factory holes in carpet up into center
console.
21. Route the DPS harness along the factory harness
and up to the radio area. Use supplied wire ties to
secure harness away from any moving parts.
22. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
23. Reinstall radio.
25. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
24. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
25. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).