Brandmotion 2000-3811 - Manual (Page 54)

Section 2: Scion iQ, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 54 of 54
16. Set DPS dip switches for Scion iQ. Flip the fifth
switch to the “up” position – “DDDDU”:
17. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
18. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
19. Turn ignition key to “LOCK” (OFF) and remove key.
24. Use supplied 24” Wire Ties to secure the DPS unit to
factory bracing. Use side cutters to trim excess from
wire ties.
25. Re-install removed parts in reverse order.
26. Use a 50/50 mix of alcohol and water to clean the
dash surface and affix the DPS sticker where
desired.