Brandmotion 2000-3811 - Manual (Page 8)

Section 3: Scion xB, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 8 of 54
9. Place DPS module under RH dash glove box area. Do not
secure with supplied 24” wire ties at this time. Route
the DPS wire harness up and over heater control as
shown.
10. Route the DPS harness along the factory wiring and
up to the radio area. Secure harness away from any
moving parts using supplied wire ties.
11. Connect the DPS harness into the radio and connect
the factory radio plug into the other end of the DPS
harness. Reconnect all connectors and antenna.
12. Reinstall radio.
13. Reconnect negative battery cable using a 10mm socket.
Re-torque battery bolt to 36 inch lbs.
14. Place DPS module with the Bongiovi DPS Acoustics side
face down. Then confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”.
15. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
16. Unplug the small 4-pin connector from DPS module.
17. Set the DPS dip switches for Scion xB. The second,
fourth, and fifth switches should be set to the “up”
position.
18. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the 4-
pin connector from the DPS module and wait another
10 seconds.
19. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should now
be sound from the speakers). Ensure radio head unit is
working properly including all speaker channels.
20. Turn ignition key to “LOCK” (OFF) and remove key.