Brandmotion 2000-3811 - Manual (Page 4)

Section 2: Scion tC, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 4 of 54
1. Ensure all radio functions are working properly, return
all Treble, Bass, Fade, and Balance to neutral settings,
and remove any CDs to avoid possible jam before
disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set parking
brake.
3. Loosen negative battery cable bolt using a 10mm
wrench. Remove negative battery cable from terminal
and position away from battery.
4. Using a plastic trim tool, disengage the 4 claws
securing the instrument cluster center panel,
disconnect the connectors, and remove.
5. Remove the 4 bolts securing the radio and remove the
radio with bracket. Disconnect the connectors.
6. Open and slightly flex the upper part of the glove
compartment door to release the 2 stoppers. Open the
glove compartment door until it is horizontal.
7. Pull the glove compartment door out horizontally to
disengage the 2 hinges and remove the door. NOTE:
Pull the glove compartment door out horizontally;
otherwise, installation failure caused by excessive play
around the hinge will result.
8. Place DPS module under RH dash glove box area. Do
not secure with supplied wire ties at this time. Route
DPS wire harness up and over heater control.
IMPORTANT: DPS is NOT compatible with factory
JBL audio systems or tC Series Release 7.0