Metrohm tiBase 1.0 Manual - Manual (Page 108)

3.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
100 ￭￭￭￭￭￭￭￭ tiBase 1.0
3.3.3 Options
3.3.3.1 Options - Overview
Dialog window: Configuration ▶ Tools ▶ Options ▶ Options
Under Tools ▶ Options, general program properties can be set on the
following tabs:
￭ General
Selects dialog language.
￭ Save
Saves settings on exiting the program.
￭ PDF
Settings for PDF files.
3.3.3.2 Options - General
Tab: Configuration ▶ Tools ▶ Options ▶ Options ▶ General
Dialog language
Dialog language
Selection of the dialog language.
Selection German | English | additional languages
(dependent on installed language patches)
Default value English
Note
For the altered setting to become effective the program must be restarted.
3.3.3.3 Options - Save
Tab: Configuration ▶ Tools ▶ Options ▶ Options ▶ Save
Save on exiting
Here you can define the settings to be saved when the program is exited. If
the corresponding check box is activated, the current view with its settings
will be saved automatically when the program is exited. If the corresponding
check box is deactivated, then any modifications that may have been made
to the view will not be saved and at the next program start the original,
manually saved view will be loaded.
Configuration settings
on | off (Default value: off)
Switches Save configuration view on/off when exiting the program.