Metrohm tiBase 1.0 Manual - Manual (Page 280)

4.8 Subwindow curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
272 ￭￭￭￭￭￭￭￭ tiBase 1.0
Statistics
on | off (Default value: off)
Shows the statistics results.
Assignment
on | off (Default value: on)
Shows the assignment.
Formula
on | off (Default value: on)
Shows the calculation formula.
Variables
on | off (Default value: off)
Displays the variables used in the formula.
4.8 Subwindow curves
4.8.1 Curves - General
Dialog window: Database ▶ Curves
Subwindow curves
The subwindows Curves 1...5 are subwindows in the program part Data-
base, in which the measuring points generated by the measuring com-
mands for the focused determination in the Determination table are
shown as a graph. When navigating in the determination overview this data
will be updated automatically (with a certain delay).
The subwindows Curves 1...5 can be switched on in the program part
Database during the definition of the layout and thus made visible. They
can be enlarged and reduced as required; they can also be maximized.
Tabs
In the curve window a tab with the corresponding command name and the
run index (e.g. Chloride.1) is provided for each execution of a measuring
command; their sequence is determined by the method.
Show curves
The curves of the selected determination are shown on the tabs with the
properties defined per window and per command type. The command type
(e.g. DET pH) is shown above the left-hand y axis.
Curves can be zoomed as often as required by spanning a section of the
curve display with the left mouse button pressed down. Zooming can be