Metrohm tiBase 1.0 Manual - Manual (Page 277)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiBase 1.0 ￭￭￭￭￭￭￭￭ 269
Table 28 Command CAL LOOP Conc
Column 2: Variable Column 3 Column 4 Column 5 Column 6
SLO SLO , mV , 1
ENP ENP , – , 3
BLV BLV , "unit from
configuration" , 2
Table 29 Befehl CAL Cond
Column 2: Variable Column 3 Column 4 Column 5 Column 6
CLC CLC , /cm , 3
RTE RTE , °C , 1
Table 30 Command STDADD
Column 2: Variable Column 3 Column 4 Column 5 Column 6
SLO SLO , mV , 1
ENP ENP , mV , 1
RES RES , "selected
unit" , 1
VAR VAR , "leer" , 3
Table 31 Command DOS pH
Column 2: Variable Column 3 Column 4 Column 5 Column 6
MR MR.MRT , mL/min ,
4 MR.MRS , mL/min ,
4 MR.MRC , "leer" , 3
Table 32 Command DOS U
Column 2: Variable Column 3 Column 4 Column 5 Column 6
MR MR.MRT , mL/min ,
4 MR.MRS , mL/min ,
4 MR.MRC , "leer" , 3
4.7.4 Results - Calculation #
Tab: Database ▶ Results ▶ Command name
For each calculation command the results and (if existent and desired) the
corresponding statistical evaluations are displayed on a separate tab Cal-
culation_#. The sequence of the shown results corresponds to that defined
in the calculation command. The display of the statistical evaluations can be
selected in the dialog window Properties result window
For every single result a maximum of the following information is displayed: