Metrohm tiBase 1.0 Manual - Manual (Page 248)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
240 ￭￭￭￭￭￭￭￭ tiBase 1.0
Input 10 digits
Default value 0
Upper limit
Upper limit for the result. This parameter is only editable when the result
monitoring is enabled.
Input 10 digits
Default value 99999.99999
Message
Only editable when the check box Monitoring result is activated.
Selection Display message | Record message
Display message
If this option is selected, the message "The limit value for the result 'result
name' has been exceeded." appears. At the same time the message is
documented, i.e. it is saved in the determination.
Record message
If this option is selected, the message "The limit value for the result 'result
name' has been exceeded." is saved in the determination.
4.5.2.6.5 Result view
Subwindow: Database ▶ Determinations ▶ Reprocess... ▶ Reprocessing ▶ Result
view
In the subwindow Result view of the dialog window Reprocessing results
and raw data are displayed on the following two tabs:
4.5.2.6.5.1 Result view - Results overview
Tab: Database ▶ Determinations ▶ Reprocess... ▶ Reprocessing ▶ Result dis-
play ▶ Result overview
On the tab Result view of the subwindow Result display the results cal-
culated during the calculating commands and the variables used for are
displayed and updated with each recalculation.
The following elements are displayed:
Title
Name of the calculation command (1C...9C).
Result
Result name, result value with defined number of decimal places, units.
Statistical evaluations
Results of the statistical evaluation (mean value, absolute and relative stand-
ard deviations, number of measured values used for the statistics).