Metrohm 899 Coulometer - Manual (Page 30)

3.4 Connecting sensors
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
20 ￭￭￭￭￭￭￭￭
899 Coulometer
Note
The electrode cable is protected against accidental disconnection
of the cable by means of a pull-out protection. If you wish to pull
out the plug again, you will first need to pull back the outer plug
sleeve.
3.4.3 Connecting a temperature sensor
A temperature sensor of the Pt1000 type can be connected to the Temp.
connector.
Connect the temperature sensor as follows:
1 Insert the plugs of the temperature sensor into the Temp. sockets of
the Coulometer.
Figure 15 Connecting a temperature sensor
Note
Always insert the red plug into the red socket. It is only this way that
the shielding against electrical interferences is ensured.