Metrohm 899 Coulometer - Manual (Page 31)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
899 Coulometer
￭￭￭￭￭￭￭￭ 21
3.5 Connecting an additional stirrer
Instead of the built-in magnetic stirrer, you can use the magnetic stirrers
801 Stirrer or 803 Ti Stand.
Proceed as follows:
1 Switch off the Coulometer.
2 Connect the connection cable of the magnetic stirrer to MSB 1 on
the rear of the Coulometer.
Figure 16 Connecting a stirrer
Note
Make sure that the flat side of the plug matches the marking on
the socket.
3 Switch on the Coulometer.