Metrohm 899 Coulometer - Manual (Page 54)

5.6 Sample data
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
44 ￭￭￭￭￭￭￭￭
899 Coulometer
5.6 Sample data
You can enter the sample data (identification, sample size, etc.) in a vari-
ety of ways:
￭ Directly in the main dialog.
￭ Using the sample table. This is particularly useful with sample series.
The sample table is a table in which the sample data for up to 99 sam-
ples can be entered (see Chapter 5.7, page 45).
￭ Automatic request immediately after the start of the determination (see
Chapter 5.6.2, page 45).
You can also send the sample size and the unit from a connected balance
in any case. With some balances, the sample identification and method
can be also sent (see Chapter 10.2, page 92).
5.6.1 Entering sample data in the main dialog
For a sample, you can enter the sample data directly in the main dialog,
even while the determination is running (see Chapter 5.9, page 52).
ID1
Sample identification. The sample identification can be used in calculations
as the variable CI1.
Entry max. 10 characters
Default value empty
ID2
Sample identification. The sample identification can be used in calculations
as the variable CI2.
Entry max. 10 characters
Default value empty
Sample size
Sample size. The value of the sample size can be used in calculations as
the variable C00.
Input range –999999999 ... 9999999999
Default value 1.0