Sindoh N700 - Manual (Page 292)

Maintenance and Troubleshooting
9-
8
6
Cut the enclosed developer pouch’s upper part of nozzle(①) and pour the developer slowly
into the holes of PCU until it is empty. (②)
Caution
- If developer is poured too fast or concentrated on specific part only, over flow may occur.
If the developer can not be poured at once, stand the PCU correctly, tilt and pour it again.
7
After pouring the developer into the PCU, wipe the developer dropped on the cover with the
enclosed cloth and attach black tape (①) along the guide lines of PCU cover.
Remove the orange tape (②), red band (③), red rubber cap (④) and black paper (⑤).
8
Press the Hook (①) on the left and push the new PCU (②) into the Machine. After installing
completely, fix the PCU with the Hook: