Sindoh N700 - Manual (Page 311)

9-
27
Maintenance and Troubleshooting
9
Message Cause Solution
Memory is full. No
more scan job
available. Do you want
to cancel this job? Memory used up during scan
data storing. “Press [YES] to cancel
current job, or press [No] to
output scanned data up to the
present.
USB Memory is full. No
more scan job
available. USB memory used up during
scan data storing. Press [OK] to cancel current
job.
USB Check Failure USB memory recognition failed. Reconnect the USB memory.
Finisher Failure Finisher cannot be used due to
Finisher error. “Select and use not Finisher but
another Delivery to in the set-
tings. For Finisher error, contact
our Call Center.”
Cannot staple paper
of this size Staple cannot be used with the
paper size. Run without staple setting or
use the paper in different size.
Cannot use the
finisher Finisher Output cannot be used
with the paper size. Use not Finisher but another
Delivery to, or use the paper in
different size.
Use ARDF only The feature can be used only
for the original applying the
ARDF. Sett the original onto ARDF to
use.
This original size is
not available The feature cannot be used for
current original size. Use the original in different
size.
Cannot use the mixed
size mode This original size does not
support Mixed Side Mode. Use the original in different size
(see
P. 2-34 Mixed Size )
Cannot use the f
inisher for this paper
type The paper type cannot allow
Finisher Output. Use the paper in another type
(see
P. 10-7 Finisher . )
Low toner Toner is no longer of any use. Prepare new toner.
Drum near end PCU is no longer of any use. Prepare the new PCU.