Vertical Communications SCS 8324S - Manual (Page 118)

Attendant Features
108 Comdial August, 03
8.7 Telephone Line Naming
You can assign names to lines to aid users in identifying the proper
line to use. A line name can be up to seven letters in length and will
show up in the user’s display.
• Name the system telephones as follows:
1. USE letter code table (page 98) to compose names for all lines requir-
ing them (up to seven letters per name are allowed) and record the
names on the line name record (page 105).
2. PRESS INTERCOM.
3. DIAL *#0*33.
4. DIAL code to choose line:
• DIAL 1# to 99# for lines 1–99,
• DIAL 100 to 128 for lines 100–128.
5. DIAL # to clear any current name.
6. DIAL 2-digit codes that correspond to letters in name (line names
must begin with a letter).
7. DIAL # to save name or cleared name.
8. REPEAT steps 4 through 7 until all telephones are named.
9. PRESS SPEAKER to end.
NOTE:If the desired line code is less than three digits, you must dial
# once after you dial the line code.
Note: If the desired line code is less than three digits, you must
dial # once after you dial the line code.