Vertical Communications SCS 8324S - Manual (Page 122)

Attendant Features
112 Comdial August, 03
8.9 System Speed Dial Numbers
You can store up to 500 system speed dial numbers at your attendant
telephone. Typically, these are numbers that are frequently called by
many different users and emergency numbers that you want readily
available to everyone. Distribute a list of these stored numbers to the
system users.
• To program system speed dial numbers,
1. RECORD the following information on the system speed dial record
sheet:
• the dialing code of the storage location (000–999),
• the line that will be used to access each outside number,
• the telephone numbers you are storing.
2. PRESS INTERCOM.
3. DIAL *#0*02.
4. DIAL code for storage location (000–999).
5. DIAL code to make your speed dial route selection choice from the
following list:
• DIAL 1# to 99# to select lines 1–99 (# must be added if number is
less than three digits),
• DIAL 100 to 128 to select lines 100–128,
• DIAL 801 to 816 to select line groups 1–16,
• DIAL 000 to select prime or last line used,
• DIAL 800 to select intercom.
6. DIAL the number to be stored (up to 32-digits long). To store a pause,
press HOLD, then continue dialing. Press TAP to store a hookflash,
then continue dialing.
7. PRESS TRNS/CNF to store number.
8. DIAL next storage location, line choice and speed dial number, AND
PRESS TRNS?CNF.
9. REPEAT previous step until all numbers are stored.
10. PRESS SPEAKER to end.