CDI Torque SURETEST Torque Calibration System - Manual (Page 14)

FUNCTIONAL DESCRIPTIONS AND SPECIFICATIONS CHAPTER 2
SURETEST DISPLAY
A 240 x 64 Full-featured Graphic LCD is used to provide versatile and clear displays of system
menus as well as measurements. Characters and symbols are displayed in different fonts:
• Maximum transducer range in the selected UNITS of measure.
• Statistical mean of all measurements in memory.
• The number of the present data memory location.
Front Panel Membrane Cursor and Function Keys
The SURETEST is supported by a powerful Graphic User Interface (GUI). Set up, Command, or
Control is done by selecting the appropriate Action Item on one of the provided Menus. Front
Panel Membrane Cursor and Functions keys are defined to guide the User in selecting an Action
Item.
There are 6 function (soft) keys: F1 through F6 . Their respective uses are clearly indicated on
the LCD.
To select an Action Item, the User simply presses a Function Key (F1-F6) to get to a Menu, uses
a Cursor Key to move to the Item, then hits ‘ENTER’ .
In addition to the ‘ENTER’ key, there are 4 Cursor Keys : UP , DOWN , LEFT , RIGHT .
The GUI also provides Prompts to further assist the user in navigating the Menus.
Power Up Sequence
Upon power up, the SURETEST automatically performs Self-tests and displays the results. Any
detected non-functional hardware will be reported on the LCD. If a 4-in-1 transducer is
connected, the SURETEST performs ZEROTARE, then displays the following default menu
while continuously checking for any activity from an input transducer :
The user can either press F1 to display previously collected data (if any) or enter Setup Mode.
Any detected torque measurement will cause the SURETEST to enter Measurements mode where
the following menu is displayed: