CDI Torque SURETEST Torque Calibration System - Manual (Page 68)

ACCESSORIES APPENDIX A
A-67
Types of Loader Testing
Torque Driver Testing
An accessory torque screwdriver testing kit, 2000-750-02, is available for use in testing or
calibrating most torque screwdrivers and "T" handled drivers. In addition to providing perfect
driver-transducer alignment, it allows the use of the 2000-600-02 loader crank for precision torque
application.
Certain torque screwdrivers, "T" handled drivers, electric or pneumatic nut runners, and non-
impact power tools must be tested by hand. Double check to be sure that the transducer you
choose is capable of handling the maximum torque that you will apply. Hold the tool exactly in
line with the transducer drive while testing. Off-axis side loading may compromise the test or
calibration of the tool.
Torque Multiplier Testing
The 2000-600-02 Manual Loader and SURETEST series transducers can be configured to test
certain torque multipliers. SURETEST also provides measurement, display, storage and statistical
analysis of multiplier output torque to 2,000 ft lbs.
In practice, the multiplier is attached to the loader using custom fixturing. The operator provides
input torque with an appropriate wrench, breaker bar or the multiplier’s integral hand crank.
Various mounting fixtures, adaptors, reaction stops and pins are available for testing the most
common torque multipliers. Ask your CDI sales representative for design assistance.
Appendix
A
Accessories
This appendix contains information on replacement parts and accessories that are
available from Consolidated Devices, Inc., 1-800-525-6319.
Refer to Figure A-1, below, for drawer and cutout arrangement information.