CDI Torque SURETEST Torque Calibration System - Manual (Page 30)

SETUP AND PROGRAMMING CHAPTER 3
3-29
3. Press ‘Enter’. The display reads:
4. Press -> or <- to select Hi or Lo limit.
5. Use Left or Right Cursor to select a digit to be changed.
6. Increment or decrement the selected digit by pushing Up or Down Cursor. Push and
hold Up or Down Cursor to change the display quickly.
7. Select and change the next digit using left and right DIGIT and up and down
Cursor. Continue until all digits are set.
8. Press (Save) to save and to return to measurements mode.
Set-up AUTO CLEAR
Use AUTO CLEAR to program the CLEAR, STORE and SEND functions for
automatic or manual operation. Use these functions in PEAK HOLD, POWER TOOL
and FIRST PEAK modes to STORE torque measurements to memory, CLEAR the
display, and SEND the last measurement captured on the display to the printer or PC.
Auto STORE and SEND are initiated at either AUTO or delayed CLEAR operations.
Use the manual modes to:
• Store the present reading by pushing STORE DATA,
• Clear a captured display by pushing MANUAL CLEAR, or
• Send a measurement to the printer/port by pushing SEND/AUTO SEND.
Use the automatic modes to:
• Store the last measurement, and/or
• Send the last measurement to the printer/port by initiating the auto or delayed
CLEAR function.
AUTO CLEAR can be programmed with a 1 to 9 second delay. Use this feature to
visually note the reading before the display clears. AUTO CLEAR with no delay stores,
prints and/or clears with no delay at the initiation of the next torque input
STORE DATA must be pressed to save the last reading. AUTO CLEAR must be
selected to use AUTO STORE and AUTO SEND.