CDI Torque SURETEST Torque Calibration System - Manual (Page 6)

5
Safety Information
Important Safety Instructions
This manual contains important safety and operating instructions for CDI SURETEST
Torque calibration system. Refer to the information in this manual often for safe
operation.
Read All Instructions
Read, understand and follow all safety messages and instructions in this manual and on
the test equipment. Safety messages in this section of the manual contain a signal word, a
three-part message.
The signal word indicates the level of hazard in a situation:
• Danger indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury to the operator or bystanders.
• Warning indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury to the operator or bystanders.
• Caution indicates a potentially hazardous situation which, if not avoided, may result in
moderate or minor injury to the operator or bystanders.
The three-part message uses three different type styles to further define the potential
hazard.
• Normal type states the hazard.
• Bold type states how to avoid the hazard.
• Italic type states the possible consequences of not avoiding the hazard.
SAVE THESE INSTRUCTIONS
WARNING
Risk of electric shock and fire.
• For indoor use only. Do not expose charger to rain or snow. Do not use in damp
locations.
• Replace defective cord immediately. Return to qualified service center for replacement.
Electric shock or fire can cause injury.
WARNING
Flying particles can discharge when applying torque.
• Users and bystanders must wear safety goggles.
• Always wear safety goggles when applying torque.
• Do not use this equipment with the power off. Always turn on the indicator and loader
so the torque and load values are indicated on the display. The safety relays only work
when the power is on. Flying particles can cause injury.