Dynojet WinPEP 7 - Manual (Page 133)

A D V A N C E D B R E A K O U T B O A R D
Advanced Breakout Board
Version 2 WinPEP 7 User Guide
E-3
C ONFIGURING THE A DVANCED B REAKOUT B OARD
The Advanced Breakout Board selection always appears checked and grayed out. The
WinPEP 7 software automatically checks to see if you have an Advanced Breakout
Board. If if you do not have one, WinPEP 7 uses the standard breakout board to
control braking.
Even though the Advanced Breakout Board selection appears grayed-out, you can
click on the configure button adjacent to it and use it to set the configuration options.
If you do not have an Advanced Breakout Board, the settings are not used.
Use the following steps to configure your advanced breakout board.
1
Connect the USB connector from the Advanced Breakout Board to USB port of
the computer where you are running the WinPEP software.
2 Verify your computer is connected to the dyno electronics and the dyno
electronics is powered on. Refer to “Dyno Electronics” on page 2-4 for more
information.
3 Verify you are in the WinPEP software’s MakeRun screen.
4 Click the MakeRun Configuration button .
5 Click the Expansion Systems tab.
6 Click the Configure button to the right of Advanced Breakout Board.
Figure E-1: MakeRun Configuration—Expansion Systems
configure button
expansion
systems tab
The Advanced
Breakout Board
selection always
appears checked
and grayed out.