Dynojet WinPEP 7 - Manual (Page 45)

G E T T I N G S T A R T E D W I T H W I N P E P 7
MakeRun and Your Dyno Electronics
Version 2 WinPEP 7 User Guide
3-11
C ONNECTING THE D YNO E LECTRONICS
The “Not Connected” message in the MakeRun Status Bar , shown in Figure 3-5,
indicates the computer is not currently communicating with the dyno electronics.
Figure 3-5: MakeRun Screen with the Dyno Electronics Not Connected