Dynojet WinPEP 7 - Manual (Page 80)

WinPEP 7 User Guide
C H A P T E R 6
Expansion Systems
6-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EXPANSION SYSTEMS
Expansion Systems allows you to view live data and graph data from other sources in
the WinPEP software. Enable a system by selecting the box next to the system name.
Selected systems will be connected to and included in the MakeRun screen and in the
data files for later viewing. The Configure button will be enabled if the system allows
further configuration.
1
Verify you are in the MakeRun screen.
2 Verify you are connected to the dyno electronics. Refer to “Connecting the Dyno
Electronics” on page 3-11 for more information.
3 Click the MakeRun Configuration button .
4 Click the Expansion Systems tab.
5 Enable or disable any of the expansion systems. A description of the expansion
systems follows.
6 If enabled, click the Configure button and make any changes needed.
7 Click OK when done.
Figure 6-12: MakeRun Configuration—Expansion Systems
Expansions systems allow you to acquire data from sources other than your dyno.
Expansion system
data channels have an asterisk (*) in front of the channel name.
Data channels without an asterisk (*) in front of their names are information from
your dyno.
configure button
expansion system