Dynojet WinPEP 7 - Manual (Page 145)

D A T A L I N K M O D U L E - H D D E L P H I E C M
Data Link Module - HD Delphi ECM Set Up
Version 2 WinPEP 7 User Guide
F-3
E STABLISHING A C ONNECTION
When you have connected your Data Link Module properly, you will see the message,
“Device Connected - ECU Communicating” displayed at the bottom of the
configuration screen as shown in Figure F-2.
Figure F-2: Device is Connected and Communicating with the ECU
If the device is not connected to your computer, or is not communicating with the
bike’s ECU, you will see an error message displayed at the bottom of the configuration
dialog box.
Figure F-3: Device is Connected but not Communicating with the ECU