Dynojet WinPEP 7 - Manual (Page 146)

WinPEP 7 User Guide
A P P E N D I X F
Data Link Module - HD Delphi ECM Set Up
F-4
T ROUBLESHOOTING C ONNECTION E RRORS
If you do not see the Device Connected - Communicating with the ECU, check to see
that you are not experiencing one of the following problems:
If you still cannot establish connection between your Data Link Module so that it is
communicating between the software and the bike’s ECU, call Dynojet Technical
Support at 1-800-992-3525 for personal assistance.
Problem TRY THIS THEN THIS
Device Not
Connected
Check that USB cable is
plugged into computer
and is making
connection.
Recheck the plug end to the
bike’s data port. This
occasionally may appear to
“snap” into place, but may not
be making connection.
Error
Communicating
with ECU
Check that bike power is
turned on and if there is a
ready to start switch it is
turned on. If necessary
start the bike.
Recheck the plug end to the
bike’s data port. This
occasionally may appear to
“snap” into place, but may not
be making connection.