Dynojet WinPEP 7 - Manual (Page 139)

A D V A N C E D B R E A K O U T B O A R D
Advanced Breakout Board
Version 2 WinPEP 7 User Guide
E-9
Selecting Data Channels for Gauges
You may select Data Channels for a gauge, from within the MakeRun screen.
1
Click the Edit Mode icon.
2 Right click on the gauge and choose Gauge Properties. The Gauge Property Editor
appears on your screen.
3 Click to expand the selections below Data Channel as shown in Figure E-7.
When you are using an Advanced Breakout Board, you will see two channels for
braking, one for each dyno drum. The Speed channels can also be applied
independently to each dyno drum.
Figure E-7: Braking Channels
%Braking 1
channel
%Braking 2
channel
yellow triangles
indicate load
control channels