Dynojet WinPEP 7 - Manual (Page 76)

WinPEP 7 User Guide
C H A P T E R 6
Run Options
6-6
Load Testing—turn on load testing and configure the parameters for step, sweep, or
custom testing.
• Enable Load Testing—turn on or off load testing. Checking this box is the
same as clicking the Enable Load Testing button .
• Load Test—select the type of load test you wish to perform: step, sweep, or
custom.
Step Testing
• Step Channel —select which channel (speed or engine speed) you would
like to use for step testing.
• Step Size —the size of the step (for example: five m.p.h.).
• Start Value—the start value for the test (for example: 40 m.p.h.).
• Hold—the value the step will hold for (for example: five seconds).
Figure 6-9: Load Testing—Step Test