Dynojet WinPEP 7 - Manual (Page 89)

A D V A N C E D M A K E R U N F E A T U R E S
Exploring Template Options
Version 2 WinPEP 7 User Guide
6-19
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EXPLORING TEMPLATE OPTIONS
The MakeRun Template Options dialog box lets you configure the gauges displayed
on the MakeRun screen. The template options are available in both Novice and
Advanced mode.
1
Make sure you are in the MakeRun screen.
2 Select Tools ! MakeRun Options ! Template Options. A description of the
template options follows.
Figure 6-19: Template Options
Use Default Titles on Gauges—automatically loads and displays the default title for
each gauge channel. If this feature is on, the titles on the gauges can not be manually
edited.
Display Units on Gauges—automatically loads and displays the default units for each
gauge channel. If a gauge does not have a separate title for the units, the units are
displayed to the left or the right of the gauge title. If this feature is on, the titles on the
gauges can not be manually edited.
• Align Left — displays units on the left side of the gauge title.
• Align Right — displays units on the right side of the gauge title.
Note: Default titles and units are only available when the program is connected to
the dyno electronics.
Default Gauge Font—applies the font to a gauge when it is created or added to the
MakeRun screen.
• Apply Font to Current Gauges — The default font is only used when gauges
are created. To apply the font to the current gauges, check the apply option
and click the Apply or OK button.