Establishing a connection – Dynojet WinPEP 7 User Manual
Page 134
WinPEP 7 User Guide
A P P E N D I X E
Advanced Breakout Board
E-4
E
STABLISHING
A
C
ONNECTION
When you have connected your Advanced Breakout Board properly, the information
for your dyno will be displayed in the Braking Information area of the Advanced Brake
Controller screen as shown in Figure E-2.
If the information displayed in the Braking Information area of the Advanced Brake
Controller screen does not match your dyno’s brake configuration, follow the
troubleshooting procedures listed in “Troubleshooting Connection Errors” on page E-
5. Jumper settings on the Advanced Breakout Board determine what is shown in the
Braking Information area.
Figure E-2: Advanced Breakout Board is Connected and Communicating Properly
information
should match that
of your dyno