Dynojet 200: Installation Guide - Manual (Page 11)

D Y N O I N S T A L L A T I O N A N D S E T U P
Introduction
Version 3 Motorcycle Dynamometer Installation Guide
1-3
Industrial Noise Control, Inc.—Industrial Noise Control, Inc. offers a zinc-coated
steel room custom built to your specifications. This room meets all dyno room
requirements. For more information on building a dyno room, read the DynoSource
newsletter Volume 1, No. 7 (published by Dynojet) included in your information
pack. The dyno room must be clean, dry, at a minimum of 32 degrees Fahrenheit (0
degrees Celsius), and have some system of exhaust extraction.
Figure 1-1: Custom Dyno Room
12 Volt Battery—A motorcycle starting system is included with your Dynojet
Dynamometer. You will need an automotive battery to use this feature. The dyno is
designed to carry a group 24 deep cycle series battery with a minimum of 600 cold
cranking amps.
Motorcycle Tie-Down Straps—Dynojet recommends using motorcycle tie-down
straps for securing the bike on the dyno. You will need to provide the tie-down straps.
Computer System—You will need to provide a computer system to run the WinPEP
software.
system requirements recommended hardware and software
• Pentium P5-100 processor • Pentium P5-133 or greater processor
• Microsoft® Windows® 9x • 28.8 K modem or better
• 800 MB hard drive • 1.2 gigabyte hard drive or better
• 16 MB of available RAM • 16 MB of available RAM (32 MB for Windows 98)
• 800x600 (SVGA) monitor • 1024x768 (SVGA) monitor
• 16k color video • 16k color video or better
• 8x CD-ROM Drive • 8x CD-ROM Drive
• 8 MB of available hard-disk space is required to install WinPEP