Installing the air hose, Figure 3-17: secure the air hose to the regulator – Dynojet 200: Installation Guide User Manual
Page 41
Advertising
O P T I O N A L A C C E S S O R I E S
Air Brake
Version 3
Motorcycle Dynamometer Installation Guide
3-11
I
NSTALLING
THE
A
IR
H
OSE
1
Install the 1-inch grommet into the hole shown in Figure 3-17.
2
Wrap the push lock fitting with thread tape. Refer to Figure 3-18.
3
Insert the five foot section of air hose through the hole. Leave enough air hose
exposed and attach it to the regulator.
Figure 3-17: Secure the Air Hose to the Regulator
grommet
run air hose
inside dyno
attach air hose to
regulator
Advertising