Dynojet 200: Installation Guide - Manual (Page 66)

Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Monitor Arm
3-36
I NSTALLING THE A RMS AND T RAY
1 Place a bushing on the pin of the first arm and insert the arm into the upright.
Both arms are identical and interchangeable.
2 Place a bushing on the pin of the second arm and insert the arm into the first arm.
3 Place a bushing on the pin of the tray and insert the tray into the second arm.
4 Insert a plastic cap in both ends of each arm.
5 Check for clearance between the monitor arm and motorcycle, walls, ceiling, etc.
Note: Dynojet does not recommend placing the computer CPU on the
monitor/keyboard tray since vibration can cause damage to the computer.
Figure 3-45: Install the Arms and Tray
tray
second arm
bushing
first arm
upright
plastic cap