Dynojet 200: Installation Guide - Manual (Page 61)

O P T I O N A L A C C E S S O R I E S
Mechanical Brake
Version 3 Motorcycle Dynamometer Installation Guide
3-31
I NSTALLING THE C ALIPER A SSEMBLY
1 Tighten the two bolts shown in Figure 3-39.
2 Remove the four bolts and washers in the top and bottom right corners (as shown
in Figure 3-39) and set aside. These bolts will be used to mount the caliper
assembly in step 3.
Figure 3-39: Caliper Assembly Mounting Bolts
3 Secure the caliper assembly with the four bolts and washers removed in step 2.
Figure 3-40: Secure the Caliper Assembly
tighten
remove bolts and use to
mount caliper assembly
remove bolts and use to
mount caliper assembly
caliper assembly