Dynojet 200: Installation Guide - Manual (Page 21)

D Y N O I N S T A L L A T I O N A N D S E T U P
Dyno Hood
Version 3 Motorcycle Dynamometer Installation Guide
1-13
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNO HOOD
There is a door safety switch included with the European dynos only. European dyno
owners will need to install this switch before reinstalling the hood. Installation
instructions are included with the switch.
I NSTALLING THE H OOD
1 Make a final inspection of your dyno and verify that all connections are tight.
2 If you have not already done so, connect the battery.
3 Carefully place the hood on the dyno leaving it propped up.
4 Secure the wires to the key switch.
Note: You must have the wires connected and the key installed to operate the
dyno. The orientation of the wires on the key switch is not important.
5 Lower and secure the hood using the four bolts you removed earlier.
Never operate the dyno with this cover removed.
Figure 1-16: Secure the Hood to the Dyno
key switch