Dynojet 200: Installation Guide - Manual (Page 62)

Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Mechanical Brake
3-32
4 Adjust the space between the brake pad and the rotor making sure the rotor is
able to spin free of contact.
Loosen the jam nut and use the adjuster nut to move the brake pads in or out.
Figure 3-41: Adjust the Brake Pad Space
I NSTALLING THE M ASTER C YLINDER AND F OOT P EDAL
1 Position the master cylinder to the inside of the dyno frame and slip the rubber
boot on from the outside. The rubber boot slips over the piston sleeve on the
master cylinder.
2 Mount the foot pedal to the outside of the dyno frame. The bolts should run from
the inside, through the master cylinder, and into the threaded foot pedal
mounting plate.
Note: Use the two 3/8 x 1-inch bolts on the top and the two 3/8 x 1 1/4-inch bolts
on the bottom. All bolts get a lock washer and flat washer.
Figure 3-42: Install the Master Cylinder and Foot Pedal
jam nut adjuster nut
foot pedal
master cylinder
3/8 x 3/4-inch
bolts for top
3/8 x 1 1/4-inch
bolts for bottom