Dynojet 200: Installation Guide - Manual (Page 68)

Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Power Carriage
3-38
2 Using a 5/32-inch allen wrench, loosen the two set screws in the lock collar and
remove it from the screw shaft.
3 Using a 7/16-inch wrench, remove the two bolts securing the flange bearing.
4 Pry the flange bearing from the carriage screw shaft with a flat screwdriver and set
aside.
Note: Clean the shaft with a fine grit emery cloth to remove any remaining thread
lock residue. This will make it easier to slide the motor assembly and flange
bearing on the shaft.
Figure 3-47: Remove the Flange Bearing
I NSTALLING THE P OWER C ARRIAGE
1 Remove the two button-head screws securing the aluminum cover to the motor
mount assembly and set aside.
Figure 3-48: Remove the Aluminum Cover
set screw on lock collar
(only one visible)
bolts
shaft
flange bearing
button-head screws
aluminum cover
motor mount assembly