Figure 3-50: power carriage secured to dyno – Dynojet 200: Installation Guide User Manual
Page 70
Advertising
Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Power Carriage
3-40
5
Secure the aluminum cover with the two screws you removed earlier.
6
Plug the power cord into a 120 volt power source.
Note: For European and 240 volt applications, a step down transformer must be
used to provide 120 volts.
7
Using the pendant, move the power carriage through the entire range of motion
making sure there is no binding or jamming.
Note: When operating the power carriage with a bike on the dyno, make sure the
bike is in neutral.
Figure 3-50: Power Carriage Secured to Dyno
pendant
aluminum cover
Advertising