Installing the fan assemblies, Figure 3-27: install the fan assembly – Dynojet 200: Installation Guide User Manual
Page 50
Advertising
Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Dual Fan
3-20
I
NSTALLING
THE
F
AN
A
SSEMBLIES
Repeat the following steps for each fan assembly.
1
Place a poly washer between the stud and the extension arm.
Note: The poly washer is secured to the extension arm with a zip tie. Clip the zip
tie before installing the fan assembly. Refer to Figure 3-25.
2
Insert the stud on the fan assembly into the extension arm.
3
If not already installed, secure the hand knobs to the extension arm and to the fan
base.
Note: Your hand knobs may be different than the hand knobs shown in the
following figures.
Figure 3-27: Install the Fan Assembly
fan assembly
poly washer
extension arm
hand knob
Advertising