Dynojet 200: Installation Guide - Manual (Page 30)

Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Dynoware EX+ Hardware Stack
2-6
C ONNECTING THE D YNO W ARE EX+ C ABLES
Attach the following cables using the cables that came in the DynoWare package. Refer
to Figure 2-5 for cable placement locations.
• Attach the 9-pin shielded serial cable to the RS-232 socket on the CPU module and
a free COM (serial communications) port on the PC. A 9-pin to 25-pin adapter may
be required at the PC.
• Attach the 25-pin shielded cable from the dynamometer to the Dynamometer
Input/Output module.
• Attach the 9-pin connector from the hand-held pendant to the Dynamometer
Input/Output module.
• Attach the 3-pin plug from the power supply to the CPU module with the flat side
facing down.
Note: The DynoWare EX+ hardware stack must be mounted in your shop so as to
be easily seen while making dyno runs.
Figure 2-5: Connecting the Dynoware EX+ Cables
3-pin power plug
9-pin, hand help
pendant 25-pin socket
9-pin, RS-232 socket
primary inductive
pickup socket