Rice Lake Ohaus Explorer Pro High Capacity Instuction Manual - Manual (Page 16)

EN-12 Explorer Pro
ADJUSTMENTS
Three soft-keys at the top of the display screen labeled UNITS,
2nd UNITS and CALIBRATE are accessed by using the arrow
buttons and selected by pressing the Enter button.
CALIBRATE
When the CALIBRATE soft key is highlighted, and the Enter button
is pressed, calibration can be performed.
2ND UNITS
When 2nd UNITS is highlighted, each press of the Enter button
cycles through the measuring units that are turned On in the
Units menu. The last option when cycling through the units is
Off.
UNITS
When UNITS is selected and highlighted, each press of the Enter
button cycles through the measuring units that are On and will
appear adjacent to the large numerals.
3.4.2 Parts Counting
Three different Parts Counting modes can be selected, Count,
Check or Fill in the Parts Counting Setup. Each mode is described
separately.
USE
PARTS COUNTING
In the Parts Counting mode, the balance displays the quantity of
parts you place on the pan. Since the balance determines the
quantity based on the average weight of a single part, all parts
must be reasonably uniform in weight.
The balance has a default setting of 10 pieces. This permits
starting parts counting immediately without setting up the balance.
The following display indicates the first time operation of parts
counting.
PARTS COUNTING 01/01/03 03:05:45 PM
SAMPLE SIZE SETUP NEW COUNT
Add 10 Pieces, Press Enter
0.00 g
0g 6100g
APW: 0.00g
Sample Size: 10
Tare: 0.00g
Tare the balance if required. With the NEW COUNT soft key
highlighted, press the Enter button. Place 10 pieces on the pan
as instructed by the blinking text on the display. Press the Enter
button.
The display now indicates the Average Piece Weight (APW) and
the sample size.
PARTS COUNTING 01/01/03 03:05:45 PM
SAMPLE SIZE SETUP NEW COUNT
20.00 g
0g 6100g
APW: 2.00g
Sample Size: 10
Tare: 0.00g
10
Pcs
*
ADJUSTMENTS
The Parts Counting display contains three soft keys at the top of
the screen SAMPLE SIZE, SETUP and NEW COUNT.
NEW COUNT
When NEW COUNT soft key is selected, follow the screen
instructions “Add 10 Pieces, Press Enter “. After pressing the
Enter button, the balance calculates the APW and the display
indicates the number of pieces.
SETUP
Select the SETUP soft key and press the Enter button. The PARTS
COUNTING SETUP is shown.
Place parts to be counted on the pan. Balance displays number
of pieces.