Rice Lake Ohaus Explorer Pro High Capacity Instuction Manual - Manual (Page 31)

Explorer Pro EN-27
The STATISTICAL RESULTS screen automatically appears and
indicates the Number of samples, Unit, Mean, Maximum,
Minimum, Standard Deviation, Relative Deviation, Sum and
Difference weights. Pressing the PRINT button will send the
screen results to an externally connected printer or computer.
Press the Enter button to exit and return to the starting screen.
Results may be displayed by selecting the RESULTS soft key at
the top of the screen.
To start a new test, repeat the entire process.
ADJUSTMENTS
START/ACCEPT
When the START key is selected, pressing the Enter button will
start statistics application. The screen displays “Add Sample
#1, Press Enter” message and the Statistics process has started.
When started, all the data from previous statistics is erased. At
this point, the soft key has changed into an ACCEPT key. When
the ACCEPT key is selected, the weight value has been accepted
as valid data.
SETUP
When selected, the STATISTICS SETUP screen will be displayed.
RESULTS
When selected, a screen will display all calculated results.
Library Name:
Allows storage and recovery of parameters and results.
When a library is recovered, the library name will replace
the application name in the application mode screen. The
library name has maximum of 18 characters.
Mode: Weighing, Animal, Check, Filling (default is Weighing)
Allows the selection of the various calculations in the final
results.
STATISTICAL RESULTS
Number Of Samples: 3
Unit: g
Mean: 0.00
Maximum: 0.00
Minimum: 0.00
Std. Deviation: 0.00
Relative Deviation: 0.00
Sum: 0.00
Difference: 0.00
Press <Enter> To Exit
Unit: g, kg, etc... (default is g)
Allows the selection of all activated units.
Number of Samples: xx (default is 3)
Allows manual entry for number of items. Only integer values
up to 100 are valid.
Filter: Low, Medium, High (default is Low)-Animal mode only
Can be set to one of three filtering levels. A higher level will
provide more accurate measurement.
Over, Under: Check mode only
Allows manual entries for the Over limit and the Under limit
values. Eight decimal places are allowed for these values.
Target: Check mode and Filling mode
Allows manual entry for the Target Weight value. Eight
decimal places are allowed for target Weight value.
Maximum: On, Off (default is On)
Allows Maximum to be turned On or Off. When Maximum is
turned on, the maximum stored sample is included into the
final results.
Minimum: On, Off (default is On)
Allows Minimum to be turned On or Off. When Minimum is
turned on, the minimum stored sample is included into the
final results.
Difference: On, Off (default is On)
Allows Difference to be turned On or Off. When Difference is
turned on, the difference calculation between the maximum
stored sample and the minimum stored sample is included
into the final results.
Sum: On, Off (default is On)
Allows Sum to be turned On or Off. When Sum is turned on,
the sum calculation of the samples is included into the final
results.
Mean: On, Off (default is On)
Allows Mean to be turned On or Off. When Mean is turned on,
the mean calculation of the samples is included into the final.