Rice Lake Ohaus Explorer Pro High Capacity Instuction Manual - Manual (Page 42)

EN-38 Explorer Pro
The display indicates the difference in weight between calibration
mass placed on the pan and the previous weight value which
was stored in the balance. After Cal Test, the display returns to
to the last application mode.
3.5.2 Balance Options
Press the Menu button, and select Balance Options.
Press the Enter button. The BALANCE OPTIONS screen is
displayed.
CALIBRATION MASSES
LINEARITY SPAN ONLY
CAPACITY MASSES MASSES
12000 g 5000g/10000 g 10000 g
22000 g 10000g/20000 g 20000 g
32000 g 15000g/30000 g 30000 g
It is recommended that masses must meet or exceed
ASTM Class 1 Tolerance. Calibration masses are
available as accessories.
Additional calibration values to be used are shown on the display
screen. The best accuracy is achieved using the mass closest
to the full span value. After calibration, the display returns to the
last application mode.
Linearity Calibration:
Linearity calibration utilizes three calibration points, one at zero
load and two at specified calibration masses. This method
minimizes deviation between actual and displayed weights
within the balance's weighing range. After calibration, the
display returns to the last application mode.
User Calibration:
User calibration is used when it is desired to calibrate the balance
using a user defined mass. The user defined mass value has
to be entered in the User Cal Weight. After calibration, the
display returns to the last application mode.
User Calibration Weight: 25%-100% of capacity (default is
Span)
Defines the mass value for User calibration. The user calibration
may now be done with the mass selected.
Cal Test:
Calibration test feature allows a check of a known calibration
mass against the last stored calibration information in the
balance.
BALANCE OPTIONS
Language : English
Display Date/Time : Date/Time
Date Format : DD/MM/YY
Date : 00/00/00
Time Format : 12 Hour
Time : 00:00:00
Contrast :
Brightness :
Audible Signal : Off
Exit
Languages: English, Spanish, etc...(default is English)
Allows the selection of English, Spanish, French, German or
Italian as the operating language to be displayed.
Display Date/Time: Time, date, etc...(default is Date/Time)
Allows display selection of Time, Date, Date/Time or Off in the
upper right-hand corner of the Application Mode screen.
Date Format: MM/DD/YY, YY/MM/DD, ETC...(default is MM/DD/
YY)
Allows setting of one of six date formats: MM/DD/YY,
YY/MM/DD , DD/MM/YY, DD/YY/MM, MM/YY/DD or YY/DD/MM.
Date: OO/00/00 (default is none)
Allows setting the present date.
Time Format: 12 Hour, 24 hour(default is 12 Hour)
Allows setting the time format of either 12 hours or 24 hours.
Time: 00:00:00 (default is none)
Allows setting the present time of hours, minutes and AM/PM.
Valid numbers change with time format from 1->12 to 0->23.
When in 24 hour mode, no AM/PM flag appears.
Contrast:
Allows adjusting the contrast level of the display.