Rice Lake Ohaus Explorer Pro High Capacity Instuction Manual - Manual (Page 17)

Explorer Pro EN-13
PARTS COUNTING SETUP
Library Name : PARTS COUNTING
Mode : Count
Unit : g
Sample Size : 10
APW : Off
Tare : 0.00
Auto Optimize : Off
Display Settings : Custom
Size/APW Key : Unlocked
New Count Key : Unlocked
Exit
Using the arrow keys and Enter button, each item on the display
can be entered and modified as required. The following
information describes each entry on the screen.
Library Name:
Allows storage and recovery of parameters and results. When
a library is recovered, the library name will replace the
application name in the application mode screen. The library
name has maximum of 18 characters.
Mode: Count, Check, Fill (default is Count)
Three different modes are available, Count, Check or Fill. The
applications for Check and Fill are described in detail after this
section.
Unit: g, kg, etc... (default is g)
Allows the selection of all activated units.
Sample Size : 0-99 (default is 10)
Defines the amount of pieces used to calculate APW (average
piece weight). Setting the sample size will force the APW field
to Off and change the APW soft key to SAMPLE SIZE.
APW: 0-999999999 (default is Off)
Defines the average piece weight. Setting the APW will force
the Sample Size field to Off and change the SAMPLE SIZE soft
key to APW.
Tare: 0-99999999 (default is 0)
Defines the weight of the container being used.
Auto Optimize: On,Off (default is Off)
Selecting Auto Optimize On will recalculate the APW value
automatically during the parts counting process up to double
the amount of parts.
DISPLAY SETTINGS
APW : On
Sample Size : On
Tare : On
Weight : On
Exit
Size/APW Key: Unlocked, Locked (default is Unlocked)
Allows locking and unlocking the soft key function in the Parts
Counting screen. If locked, the message “Key Is Locked” will
be displayed in the message bar.
New Count Key: Unlocked, Locked (default is Unlocked)
Allows locking and unlocking the soft key function in the Parts
Counting screen. If locked, the message “Key Is Locked” will
be displayed in the message bar.
Exit:
When selected, balance returns to the Parts Counting Mode.
SAMPLE SIZE/APW
With SAMPLE SIZE soft key highlighted,press the Enter button.
The PARTS COUNTING display is shown with the value of the
sample size highlighted. Using the arrow buttons and the Enter
button, the sample size value can be changed.
After the Enter button is pressed, and a new sample size has
been entered, remove the sample and place parts to be counted
on the balance using the new sample size.
APW
With the APW soft key highlighted, press the Enter button. The
APW is highlighted at the lower left of the screen. Using the
arrow buttons and the Enter button, the APW value can be
changed.
For higher quantities, the APW will not be recalculated. During
the auto optimization process, the message “Auto Optimizing,
Please wait” will be displayed in the message bar on the screen.
Display Settings: Custom, Default (default is Default)
Selecting Display Settings to Custom will bring up the DISPLAY
SETTINGS screen that will allow individual display items to be
turned on or off. Selecting Exit will return balance to previous
screen.