Rice Lake Ohaus Explorer Pro High Capacity Instuction Manual - Manual (Page 27)

Explorer Pro EN-23
Tare Required: Off, Single, Dual (default is Single)
Allows selection of Tare Required. When Off is selected, the
balance will not prompt for container. When Single is selected,
the balance will prompt for the initial container weight. When
Dual is selected, the balance will prompt for the initial
container weight and final container weight.
Auto Sample: Off, On (default is Off)
Allows Auto Sample to be turned on or off . When Auto Sample
is turned on, the Differential Weighing process is automatic.
Clear All Data: No, Yes (default is No)
All the data from the Differential Weighing process will be
erased when Yes is selected.
Display settings: Custom/Default (default is Default)
Allows Display Settings to be set to default or custom. If Display
Settings is set to custom, information on the result lines of the
Differential Weighing mode can be individually turned on or
off. If Display Setting is set to default, all the information is
turned on.
View Results:
Allows the calculated results of the Differential Weighing
process to be viewed.
Exit:
In the sub menu, will return to the previous menu.
In the main men, will return to the last application mode.
ADJUSTMENTS
START/ACCEPT
When the START key is selected, pressing the Enter button
will start differential weighing application. The screen displays
“Place Initial Container X, Press Enter” message and the
Differential Weighing process has started. When a new
process starts all the data from previous Differential Weighing
is erased. At this point, the soft key has changed into an
ACCEPT key. When the ACCEPT key is selected, the weight
value has been accepted as valid data.
SETUP
When executed, the DIFFERENTIAL WEIGHING SETUP screen
will be displayed.
EDIT
When executed, an edit screen will display that will allow an
user to re-sample a sample weight, or to delete an undesirable
sample, or to continue.
Library Name:
Allows storage and recovery of parameters and results.
When a library is recovered, the library name will replace
the application name in the application mode screen. The
library name has maximum of 8 characters.
Mode: Weight, Percent, % Retention (default is Weight)
Allows the selection of the various calculations in the final
results.
Units: g, kg, etc...(default is g)
Allows the selection of all activated units.
Number of Samples: xx (default is 10)
Allows manual entry for number of samples. Only integer
values up to 80 are valid.
Total Weight: xxx.xx (default is 10.00)
Retention Mode only, allows manual entry for the Total
Weight value. Total Weight has to be less than the balance
capacity.