Torbal AD50 Series Manual - Manual (Page 23)

Instruction Manual - TORBAL AD Series
3. After enabling parts counting, select the sample size you want to be used for establishing the
average piece weight (APW). SPL – 10 will be displayed indicating that the default sample size
setting is 10 pieces. To accept the sample size press the “T” (YES) key. To change the sample
size press the 0 (NO) key.
To Accept To Change
The sample size selection can range from 1 to 100 pieces. By applying short single presses to the
0 (NO) key the sample size will change in increments of one. By holding the 0 (NO) key
pressed, the sample size will change in increments of 5. To select a sample size of 99, press and hold the
0 key until the display reads 95, and apply four single presses until the sample size reads 99. Once a
desired sample size is displayed, press the “T” (YES) key to accept and confirm the selection.
Note: Larger sample size results in a more accurate average piece weight. Select a sample size greater
than 10 pieces if a large weight variance might exist between the counted pieces.
4. After selecting the sample size, DONE will be displayed indicating that the function has been
configured and it is ready to use. To use the function follow the directions in Chapter 8. To exit the
mode menu use the “C” key.
23