Torbal AD50 Series Manual User Manual
Page 51
Instruction Manual - TORBAL AD Series
Note: If filling does not begin while the command FILL is displayed, after approximately 5 seconds the
scale will display 10pcs and will wait for the count to begin.
8. The display will now indicate the number of pieces placed in the container. Stop filling when
the desired count has been reached.
9. Once an accurate piece count has been taken, the container and its contents may be removed
from the scale. After the container with the counted pieces has been removed, the scale will
indicate the count is finished and that a new count may be initialized by pressing the “C” key.
The command “ ---, COUNT FINISH, TO START COUNT PRESS C will appear on the display
sequentially. To start a new count press the “C” key.
Note: If too many pieces have been placed into the container, remove the excess while the
container is still on the scale’s pan. You may also remove the container from the pan, remove
the extra pieces, and place it back on the pan to recheck the count. This may be performed
51