Torbal AD50 Series Manual - Manual (Page 33)

Instruction Manual - TORBAL AD Series
6. Once enabled, GLP options will begin to scroll on the display: Model No., Unit ID, User ID, and
Project No.
7. Press “T” (YES) when the desired option is displayed.
8. A minus sign will be displayed, indicating you may assign a new ID or project number.
Note: ID numbers can consist of up to six digits long.
9. To enter an ID or a number, use the following keys: 0(NO) to increment a digit, “T” (YES)
to accept and go to the next digit, “F” to accept the entire setting, and “C” to clear and start over.
To become familiar with entering an ID, refer to the example in Table 7.1.5.9.
To increment and change digits To accept and move to the next digit
33